You must be an admin to perform this action as access to the settings is required. If you do not have access, please speak to your GoBright Administrator.The GoBright App must be installed on your phone and you must be logged in as an Administrator.To reset the GoBright Interact device, log in to the GoBright portal and head to Settings > Devices > Interacts.Delete the device (step 3 above).The device will then show as offline:Place your finger on the 'Offline' section and swipe down to bring up the following:Select recommission and then confirm you wish to recommissionThe Interact will rebootYou are then presented with a QR code that needs to be scanned.You now need the GoBright App. Load the App and click on the 3 horizontal lines in the top right to bring up the settings menuSelect Admin toolsSelect GoBright InteractsSelect 'Commission an Interact by QR code'Select your commissioning presetScan the QR code on your phone that is logged in with an admin accountComplete the next page and make sure the Interact is coupled to the correct room / desk / parking spaceSelect 'Commission Device'After approximately 30 seconds the device will reboot.If your device is stuck on 'Connecting MQTT over TLS' please ensure that the following firewall rules have been applied:Outbound 8883 - Traffic over MQTT over TLS to the GoBright platformThe full firewall configuration can be found here:https://support.gobright.com/hc/en-us/articles/360010024559-Firewall-configuration